Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About BHDJon

Re: Configuring MS425 stack IP

by in Switching
‎Jun 10 2021 7:22 AM
2 Kudos
‎Jun 10 2021 7:22 AM
2 Kudos
I was getting wrapped up in thinking these switches behaved like some others I've worked with that treat management as a single plane in stacks.  With that out of the way, I think it makes sense now and will continue with setting up the routing and SVI's without dwelling on the management IP's.   Thanks Jon   ... View more

Re: Configuring MS425 stack IP

by in Switching
‎Jun 9 2021 1:54 PM
‎Jun 9 2021 1:54 PM
Ok well this seems to be the case with the 425's.  Each member has a unique management IP rather than there being a single stack management IP.  I haven't configured this series of switches before so this isn't quite intuitive yet.  In the switch stack menu I see that L3 routing can be applied to the stack, so that may be able to take care of my needs if I can create SVI's that have the same routing table across the stack members.   Thanks, Jon   ... View more

Configuring MS425 stack IP

by in Switching
‎Jun 9 2021 10:10 AM
‎Jun 9 2021 10:10 AM
I'm setting up a pair of MS425-16 switches in a stack.  It seems to be working correctly, but I notice that each switch pulls a unique IP address rather than the stack sharing one virtual IP.  Another stack of MS390's I'm setting up behaves more like I'd have guessed and presents one virtual IP for the whole stack.  Are the MS425's designed to behave differently?  If so, what is the recommended configuration?  I see that VRRP is supported - is that how I should be configuring the MS425's?   Jon   ... View more
My Top Kudoed Posts
© 2024 Cisco Systems, Inc.