Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Eric_McClure
Eric_McClure
Here to help
Member since Oct 6, 2020
Aug 15 2024
Eric McClure
Quebec
Community Record
11
Posts
0
Kudos
0
Solutions
Badges
Aug 15 2024
10:01 AM
Yes we seem to have the same issue anything from Meraki support ?
... View more
Mar 4 2021
8:31 AM
Hi, We are in the early testing of adding VOIP. We use an MX68 and we have wan1 with normal internet and wan2 is an LTE modem for backup. I would like to know if there's a way to block voice when wan1 fails. Basically no voice VLAN (VOIP) on wan2? Thanks
... View more
Nov 20 2020
8:38 AM
Yes that is true, we're in talks with Meraki. It should not create the route in the route table if the equipment has never connected / fetched config. Very good help from the support and thanks to everyone for the help.
... View more
Nov 19 2020
10:05 AM
No it is not the only route we create the network before hand so that we can do the switch the next day but don't need so much ressources. So the "original" route is on the DMVPN network and is still up.
... View more
Nov 19 2020
7:08 AM
Yes we are opening a ticket with Meraki Support. But I still wanted to check with the community. Thank you so much for your response I hope we can find the solution.
... View more
Nov 19 2020
6:20 AM
Yeah only issue is that option is in our template, all networks are bound to a template if I change something to the template is changes for all networks.
... View more
Nov 19 2020
5:04 AM
Hi everyone, So I have question to see if anyone else has came across the same problem. I create my network with a API script the day before to simplify the job for the technicien that goes to install the next morning. The issue is, we noticed that when I run the script, even if the equipment's are not installed physically so the network is down, Meraki has the "route' already setup. So the issue we have is when the route is announced before hand the other networks on the same subnet can't reach the network that is still up with old equipment since it's taking the path directly to the Meraki network that is not operational yet... Anyways hard to explain but does anyone know if we can have Meraki not announce the route until the network equipment's are starting their config ?
... View more
Oct 21 2020
1:18 PM
Ok so I don't need to link them to network right away just have them calimed? So the way we work is we have template in that template we create the network. And then we add the equipements. Well we actually use a script to create the network and in that add the equipements (time saver). I''m just trying to see if I can have like 10 or so MX and MS already connected to the cloud to get the basic config so I don't have to run the script in advanced. So when we arrive on location run the script plug the MX and it just applies the scripts config and we gain time.
... View more
Oct 21 2020
6:27 AM
Ok, that's what I thought. We're installing over 300 networks and we can't have our clients go offline for a long period of time so i'm trying to see if we can save time by having the config be downloaded before hand without creating the network in Meraki.
... View more
Oct 21 2020
6:12 AM
Quick question, does the MX or MS have to be added to a network to start downloading the config?
... View more
Oct 7 2020
10:20 AM
Hi, My name is Eric, I'm a Network Administrator with Familiprix and we use Meraki products every day. I can't wait to browse this forum for great ideas and valued help !!
... View more
© 2024 Cisco Systems, Inc.
