Hi,  I've noticed that on some upstream switches to some of my MX appliances(MX75) on the WAN connection I get occasional "Ethernet port carrier change" events and notice that there is a definite disconnect and reconnect.  Usually its only for 5-30 seconds and can go hours without one and then have many.  I know many posts say to check cabling but with the same exact cabling i can swap out the switch and it completely disappears.  It was a little ironic when i first noticed it was when I was using some 8 port Cisco SBS switches.  I have found that the Netgear GS108T seem to be most reliable and doesn't exhibit this problem.  I recently saw the problem with a small 8 port HP switch as well.  Since it doesn't appear to be cabling related I wanted to find out if anyone else has seen this as well?  I can open a support ticket and have them investigate as to maybe more details if needed.  Just thought i'd ask here first.  Thanks ... View more

Hi,   Maybe a silly question but I am trying to accomplish a "dry" VLAN on a Meraki MX/MS setup.  By Dry I mean i'd like to assign ports to a VLAN and have traffic pass between those ports and devices connected to them but was hoping to not have to set an MX IP address or address scope.  Essentially having no interaction with Meraki MX, just a virtual cable if you will.   Regards, -m ... View more