Correct, use to do this before MX15 firmware and above. They appear to have removed a basic SD-WAN feature as there obviously wasn't a device/hardware limitation.  ... View more

Nice! 😍 ... View more

>I'm going to 500Mbps now   The MX67 and MX68 are the best fit here with 450Mb/s of throughput. ... View more

Wow, I learn something new every day. ... View more

👌👏✔ Perfect ... View more

Very cool Swag! Thanks Meraki! ... View more

Hold still here ... View more

Don't worry, I'm a CCNA Wifi. Network design is not the issue here. I tested with Cisco light and wlc managed APs of my lab and this thread is just to avoid loosing the Z. I would keep it only as a Nat device but due to the bandwidth issue and this Non standard AP posture, I'm dropping it definitely. ... View more

Congrats guys ... View more

Hey!, I'm not listed 😉 ... View more

Quite the same, but thank you about the timeframe of firmwares.   My last broadband ISP contract was symmetric for 100mbps and traffic shapping was set to simple and 100mbps. Speedtest.com tests could easily reach 100mbps.   My newest contract is 240/40, so asymmetric band, and then I went there and set accordingly. Speedtest.com tests, lots of them on lots of different servers and also using MacOS app, never gets higher then 60mbps.   Called meraki support and got only that it should never go that speed... just 50mbps as stated on PDF.   So... it's too confusing and I'm pretty sure the latest firmwares are doomed.   ... View more

So, I have a Z1 for years and hope it gets up for more until it's 10-years license ends 😉   My last broadband ISP contract was symmetric for 100mbps and traffic shapping was set to simple and 100mbps. Speedtest.com tests could easily reach 100mbps.   My newest contract is 240/40, so asymmetric band, and then I went there and set accordingly. Speedtest.com tests, lots of them on lots of different servers and also using MacOS app, never gets higher then 60mbps.   Called meraki support and got only that it should never go that speed... just 50mbps as stated on PDF.   So... should I really trust on the GUI that says that the top speed of Z1 is 1gpbs ?   ... View more

Interessante teste.   Quando você desconecta o link WAN reparou se o NAT passa a ser realizado no modem? Pois as  portas LAN funcionam como um switch, se seu dispositivo faz NAT, esse comportamento é esperado.    A primeira informação confere. Essa funcionalidade NÃO é suportada no Z1, portanto, para usar em casa num teste,ok... em cliente não recomendaria.   abs.  ... View more

👍 ... View more

No problem...    ... View more