We have over 200 AppleTVs in our campus. I disable Bonjour to block AppleTV broadcasting over network. Clients will be able to find the nearby AppleTV via Bluetooth.  ... View more

I opened a case with Meraki about this bug more than 2 months ago. Cann't understand why 25.14 still is marked as stable version ... View more

Hi,   I have not tried PSK or Open. I'm testing to enforce VLAN via Group Policy to see if it helps. In our network, the authentication issues still the same (mostly happen to BYOD). ... View more

Thank for your ideas..   The problem happens even when we roams between 2 APs near by. I set minimum connect speed of 18Mb/s and the client get 75+Mbps speed test to that AP (after it reconnected). We did not config RX-SOP.   The clients are Mac Air (2017 and 2018), some Windows computers....   It's strange as the client starts working automatically if a new client join into the AP   ... View more

Also, I just discovered interesting things:   - Client A (Vlan x) connects to AP-1: Everything works well - Client A roams to AP-2: Traffic drop, cannot ping to vlan gateway either. - When Client A turn off then turn on WIFI OR New Client B (same VLAN x with client A) connects to AP-2  : Client A start working again    Our SSID is configured with Bridge Mode, Radius overwrite VLAN.  Layer 2 and Layer3 are Meraki switch stack.     ... View more

Hi,   For your trunk ports, I just leave the Native VLAN blank.    Is this OK or should I set a native VLAN? ... View more

I have a case that been opened for around 2 months with the similar problem, 04247935   I tried firmware 25.13; 25.14; 26.5; 26.6 but no luck   ... View more

I have the same problem with a Mac Firstly, we applied the Block Group policy to this client. Few hours later, we move back to normal Policy. So now, the client have normal policy but it keeps showing the splash page.   We have had too many bugs with Meraki (AP and Switch) recently.  ... View more