Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Dudley5526
Community Record
10
Posts
1
Kudos
0
Solutions
Badges
2 weeks ago
1 Kudo
Thank you for all of your help. VPN was enabled on VLAN1 on the MX but the Client VPN Server was disabled. I disabled the VPN mode on the VLAN and the device that was in port one obtained an IP address from the MX's DHCP. Couldn't have figured it out without you.
... View more
2 weeks ago
I re-enabled RSTP; the STP guard was already set to disable. Should the MX Uplink be set to Dynamic? Its IP address is different than the VLAN. It also set as a WAN, should it be a LAN
... View more
2 weeks ago
The Switch settings on the hub VLAN configuration: Management VLAN is 1 I don't have any switches on the spoke
... View more
3 weeks ago
Good afternoon Rwelch! I enabled the default VPN settings on the spoke. The default 192 subnet is likely the native vlan (set trunk downlink to ms120 as that vlan) and in the allowed vlans on the downlink allow both the native vlan and client vlan. How do I set the trunk downlink to the MS120 as that vlan? This is the port on the MS120
... View more
3 weeks ago
I changed Port 4 from drop untagged traffic to Native Vlan, and it disappeared. How do I get it back? This is the other 3 This is the Site-to-Site VPN settings. Are they correct? I inherited this network. I've had to untangle other setups. Thank you for your help!
... View more
3 weeks ago
I have a site-to-site VPN using a MX250 as the hub and a MX64W as a spoke. The MX64W is connected to the network using a CAT6 cable connected to an MS120 switch in the main network closet. Wireless connections on the MX64W receive dhcp addresses from the vlan setup on the MX64W and are able to access the Internet. There are 4 ports on the MX64W and I don't get any connectivity. Where should I look?
... View more
Nov 18 2024
12:42 PM
We have been using MDM for 18 months. We have figured out a lot but still have questions. Where or Who is the best place for MDM training? Or maybe some consulting time where we could ask questions specific to our environment.
... View more
Labels:
- Labels:
-
Other
Nov 18 2024
12:37 PM
We have been using Meraki MDM for 18 months in supervised mode. Can we switch to Federation authentication without resetting devices? All our devices are iOS
... View more
Labels:
- Labels:
-
Enrollment
© 2024 Cisco Systems, Inc.
