Hi community. please understand that English is not my first language. MX67 can't received ip ISP device config maybe DHCP setting because if i do pc connect to direct ISP device then PC receive ip and can serviced internet customer also have LTE device I see the problem here when i connect internet port to LTE device internet port can receive ip. but ISP device connect to MX67 internet port MX cannot receive ip and port link up(if connect LAN PORT 2, MX can receive ip and link up) Why is this problem happening? i done change MX device, reboot and reset but same symptoms can you give me some advice?   thank you ... View more

Hello, community.   I'm managing a meraki network with a template. I'll going to set up NETFLOW setting. But I know if set up NETFLOW then have to take off the template and apply NETFLOW. Is there a service impact when removing the template? Also, after the NETFLOW setup is completed, will there be any service impact when the template is re-installed? I wonder if physical support (on-site support) are also necessary when there is an issue in the network. I'm curious about these. If there's an official document, please share URL.   thank you ... View more

Hello, I'm administrator who is new to the network. I'm posting on the community because I have a question. When I look at the route from MX equipment to MTR, and when you look at the route from MS equipment to MTR The paths come out differently. MX is shows a direct the destination ip. BUT MS shows the paths and the destination ip. Is it because MX and MS operate differently? MS will also go to destination via VPN tunnel on MX at the top, but I don't know why. Please give me a lesson. Thank you. ... View more

Hello, I work network engineer in South Korea. Please understand that I post through a Papago translator because I am not good at English. Currently, we are planning to change MX HUB priority using Meraki API. The official document is limited to processing 10 requests per second and It seems normal only when the priority is changed by 10 per second. I wrote the Python code in visual studio and config a test network of about five spoke. However, unlike the official document, when the code was executed, it took 10 seconds to change the priority. Is there a solution to this? Thank you. ... View more