Meraki

jlock8191 · ‎Apr 22 2024

Hi all! I just wanted to add that this is resolved. I believe cycling the ports individually messed up the agg ports. After recreating the agg ports from the bottom up, the issue is now resolved. Thanks everyone for your replies!

jlock8191 · ‎Apr 19 2024

Apologies, I never changed the ports, we are still using the same 2 ports for the agg port. When switch 2 wouldn't come up, I cycled the agg ports individually and was curious if that might have caused this issue. I do have a ticket in but figured I would see if the community might have some ideas in the meantime. Thanks!

jlock8191 · ‎Apr 19 2024

Good morning, I am new to the Meraki side of things. We noticed a WAP only negotiating at 100mbps. Due to this, I decided to start with a simple switch reboot. After the reboot of switch 1, switch 2 and 3 went down as well due to them getting their feed from Switch 1. I waited awhile, but switch 2 never came up, which leads to switch 3 not coming up. I eventually cycled the ports manually and got switch 2 up, however I believe I may have messed something up. Since I manually toggled the physical ports, the agg config is barking at me. Mentioning "port running LACP and LACP has disabled this port" I did the same thing between switch 2 and 3 which is giving the same error on its downlink port to switch 3. Switch 3 is giving occasional "DNS mismatch" messages. Not consistently, but it is definitely having issues keeping clients connected. Any enlightenment on what I messed up would be amazing. Thanks!

jlock8191 · ‎Apr 15 2024

Thanks! I tried both with no luck but I am starting to see a pattern. Looks like it is oddly all ports on Switch 1, up to port 18. After port 18, everything is 1gig. All the rest of my switches are fine and negociating at 1gig. I noticed have a firmware update to run, I am going to give that a shot and see if it resolves the issue.

jlock8191 · ‎Apr 15 2024

Thank you! I am looking at this now and seeing that the auto-negotiate on the switch port with the slow AP is coming up as 100mbs. Now I just need to figure out why. Digging now, just glad I know where to look. Thanks again!

jlock8191 · ‎Apr 15 2024

Good morning, all! I inherited a Meraki network and am loving the simplicity. I noticed in one area of the office users were letting me know of slowness. I ran a speed test and got about 50mbs, I also ran a throughput test via Meraki and it didn't show much better at 80mbps All 5 other APs are all working find with over 600mbs. I have already rebooted the AP and unfortunately no change occurred. Any ideas? I am doing research online, however it seems most the AP slowness issues are regarding all the APs and not just one. The AP is a MR46 Thanks!

Meraki

Community

About jlock8191

jlock8191

Community Record

Badges

Re: Agg ports not working correctly after Switch Reboot

Re: Agg ports not working correctly after Switch Reboot

Agg ports not working correctly after Switch Reboot

Re: 1 of 6 APs running much slower than the rest (MR46)

Re: 1 of 6 APs running much slower than the rest (MR46)

1 of 6 APs running much slower than the rest (MR46)

Re: Agg ports not working correctly after Switch Reboot

Re: 1 of 6 APs running much slower than the rest (MR46)

Re: 1 of 6 APs running much slower than the rest (MR46)

Re: Agg ports not working correctly after Switch Reboot