VLAN tagging on WAN

[Purtech]

I want my untagged default production VLAN and a Tagged VLAN 99 to be transmitted over my MR66's. I turned on the Tagging and it knocked my untagged VLAN out.

How can I make them co-exist?

Mike

[ww]

you can use 2 different ssids?

[Purtech]

Yes, that it what I plan on doing.

[Purtech]

But the SSID's will be on OTHER APs not the Meraki.

[ww]

yes that is where you add the vlan tag.  and the other ssid "dont use vlan tag"

[Purtech]

Right, but on the Meraki, I went to add the Tagged VLAN and it knocked the Untagged one out. How can I add the tagged leaving the other one alone? I looked around in the interface...didn't see an option. On switches you can have both Untagged and Tagged VLAN's on the same port.

[ww]

so you have 1 ssid untagged. 

when you add a second ssid and set that with a vlan tag.

the ssid1 also is not untagged anymore?

[Purtech]

Yes. One tagged, one not. Both VLAN's going to a Cisco WAP371 that separate them into two SSIDs. One tagged one not.

I just need to broadcast them thru the Meraki's.

(The untagged is simply the default VLAN. I added the Tagged one to send that traffic to a guest network/ISP.)

[SamDaniels]

Are you using the MR66's as a bridge pair? If so, they only support one VLAN I do believe,  please see below

https://documentation.meraki.com/MR/Deployment_Guides/Mesh_Deployment_Guide_(CVD)#Typical_Deployment...

Look at ethernet bridging section

[nvrdone]

Switchport set as access instead of trunk??