VLAN tagging on WAN

Purtech
New here

VLAN tagging on WAN

I want my untagged default production VLAN and a Tagged VLAN 99 to be transmitted over my MR66's. I turned on the Tagging and it knocked my untagged VLAN out.

 

How can I make them co-exist?

 

Mike

9 Replies 9
ww
Kind of a big deal
Kind of a big deal

you can use 2 different ssids?

Yes, that it what I plan on doing.

But the SSID's will be on OTHER APs not the Meraki.

ww
Kind of a big deal
Kind of a big deal

yes that is where you add the vlan tag.  and the other ssid "dont use vlan tag"

Right, but on the Meraki, I went to add the Tagged VLAN and it knocked the Untagged one out. How can I add the tagged leaving the other one alone? I looked around in the interface...didn't see an option. On switches you can have both Untagged and Tagged VLAN's on the same port.

ww
Kind of a big deal
Kind of a big deal

so you have 1 ssid untagged. 

when you add a second ssid and set that with a vlan tag.

 

the ssid1 also is not untagged anymore?

Yes. One tagged, one not. Both VLAN's going to a Cisco WAP371 that separate them into two SSIDs. One tagged one not.

 

I just need to broadcast them thru the Meraki's.

 

(The untagged is simply the default VLAN. I added the Tagged one to send that traffic to a guest network/ISP.)

Are you using the MR66's as a bridge pair? If so, they only support one VLAN I do believe,  please see below

 

https://documentation.meraki.com/MR/Deployment_Guides/Mesh_Deployment_Guide_(CVD)#Typical_Deployment...

 

Look at ethernet bridging section

nvrdone
Here to help

Switchport set as access instead of trunk??

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels