Printer not working connected to Meraki AP SSID

[PJB]

Hi there,

I have created a test network. Essentially, 1 SSID (10.10.10.0/24) I have only a laptop and a printer connected via the AP. So Wirelessly connected to the same SSID and I cannot print anything. I have tried pinging the printer from laptop and no joy. I have all relevant drivers connected etc. I used my phone as a hotspot and connected both and all worked as expected. Any help much appreciated. My full kit is..Meraki MX to Switch to AP. Nothing crazy just 1 vlan created for the Test SSID and trunked all the way from MX to AP.
Any help much appreciated

[ww]

Check if you mr ssid firewall is blocking anything on L3 or that l2lan isolation is enabled

https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/'Deny_Local_LAN'_settings_in_Cisco_...

https://documentation.meraki.com/MR/Firewall_and_Traffic_Shaping/Wireless_Client_Isolation

[PJB]

Hi there,

Many thanks for your reply. I can see L2Lan isolation is not enabled (Which is correct?) and no deny rule in place. Any other suggestions much appreciated

[alemabrahao]

Could you please share the SSID configuration with us?

[PJB]

Still having the issue. Also from the dashboard I can ping the printer from all other SSID's Vlans I set up, which I dont want, especially the test guest SSID. I have attached all relevant information. Hope you can shed some light on this.

[alemabrahao]

Quick question, are both printer and device receiving IP?

[PJB]

Hi there,

Yes both printer and device are receiving IP. I can ping them both from Meraki dashboard from all vlans. 

[alemabrahao]

What firmware version are you running? Have you tried with a different firmware version?

There is no special setting to enable, so if it doesn't work with a different firmware version, my suggestion is to open a support case.