- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CW9178I Running 2 x Ethernet Ports LACP not coming back on line after upgrading firmware.
I have a CW9178i Connected to a MS150 on two 5G ethernet ports The AP and the Ports running LACP. All works well except when you upgrade the firmware... the AP does not come back online... when you check the switch the first port gets disabled by LACP and the AP hangs and never joins the cloud. A power cycle does not fix. to get it back you need to disable the LACP pair and disable the second port. The AP comes on line. You can then enable the second port and set to LACP and all works again. It would be nice if this was not required !!!
I notice I need to set the AP to "Link Aggregate: Enabled" once it is back on line could it be that this setting goes back to disabled after SW upgrade ???
Any ideas why this happens...
I have also noticed that there are no port profiles for this model AP
There is no 2-port with USB ?
Also when running the AP on 1 port Port 0
Show correct here as Port 0
but here it is Ethernet 1
When working
Why are the ethernets now 1 and 2 ??
BTW is there a way to calibrate the tilt sensor it is 100% at 0 degrees !!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Interesting 1 hour later it is still working but show LACP disabled on dashboard but working..
on the summary page... show not enabled but lower it show enabled..
on the ports page it is enabled
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've seen this as well for a while now in the dashboard for the "new" view where it's enabled but parts of the new UI show disabled still but the settings show correctly enabled. Very annoying.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think at least your port profile is ok as it is "1 (additional) port and USB".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Arr this make perfect sence now "Additional" and for the hospitality AP too. They should make this more clear...