VLAN Trunking with Meraki switch

Anonymous
Not applicable

VLAN Trunking with Meraki switch

Like simple diagram shown,

 

I configure Meraki switch Port 23 and 24 as Trunk with "Allowed VLANs" set for All.

 

Specific VLANs are tagged on the links from the ESXi hosts into the Meraki switch. So does this mean VMs on the same VLAN running on ESXi 1 and 2 can communicate with each? Or I still need to do other configuration on Meraki switch to make the layer2 forwarding work?

 

Trunk with Meraki.jpg

2 REPLIES 2
Bruce
Kind of a big deal

Should work. If VMs are configured on the same VLAN then they should be able to communicate with each other - you don't need to do anything on the Meraki switch other than establish the trunks.

By default a port on a Meraki switch is configured as a trunk port and allows all VLANS. You shouldn't have any issue getting this to work. 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels