Port not forwarding traffic due to access policy

Solved
tim_k
Conversationalist

Port not forwarding traffic due to access policy

Hello everyone,  hope you’re all doing well.

 

I am receiving the "Port not forwarding traffic due to access policy" alert from time to time on my Meraki Switch (MS130-48P, is updated to latest stable Firmware).

 

So, I have configured a port on Switch for our Print Server and it is working properly, but from time to time it is giving me the mentioned alert. When receiving the alert I'm not seeing any impact on the Printer.

Port is configured as Access Port with Access Policy enabled to allow a specific MAC (Printer's MAC address, se screenshot).

tim_k_0-1728378884250.png


Tried with Meraki Support but no luck, also did a research but found nothing helpful.
Has anyone encountered a similar problem or what could be the issue?

Thanks in advance.

1 Accepted Solution
GIdenJoe
Kind of a big deal
Kind of a big deal

Could the printer's LAN port be going into sleep mode?
Some devices that use WoL change their behavior when the LAN port goes into sleep mode.  Perhaps the switch is not liking it.

View solution in original post

4 Replies 4
cmr
Kind of a big deal
Kind of a big deal

If you look at the client list for the time covering the alert and limit it to just the particular port on that switch, do you see any MAC addresses other than the one you know for the printer?

If my answer solves your problem please click Accept as Solution so others can benefit from it.
aml
Here to help

Yes, I've seen something similar - the switch reports that it's not forwarding traffic, but if you send a job to the device it does get printed, and you get a reply if you ping the device by IP address (although the first couple of packets are lost before you get a response).

 

I swapped both printers and switch ports and the behaviour follows the specific device, but I did notice that it only happens when Xerox MFP devices are connected (HP/Canon devices are ok)

 

I suspect that it's the copier going into Sleep/power saving mode and the switch stops forwarding traffic because it's not receiving the expected response from the printer.

 

I tweaked the option to enter power saving mode after 1 hour (from memory I think the default was 15 minutes) but it's still happening, and I gave up researching after I couldn't find anything to confirm the above on Meraki/Xerox/google, etc

 

Snip from this morning:

Screenshot 2024-10-11 082350.png

 

 

 

 

 

 

 

 

GIdenJoe
Kind of a big deal
Kind of a big deal

Could the printer's LAN port be going into sleep mode?
Some devices that use WoL change their behavior when the LAN port goes into sleep mode.  Perhaps the switch is not liking it.

tim_k
Conversationalist

Hi everyone, sorry for responding late as I have been off for some days.

My suspicion was that printer goes to sleep, hence changing also the speed link from 1Gbps to 10Mbps.
The thing is that I manage the the firewall and the switch remotely, so will need to send someone to check the Printer to be sure. There is someone else managing the infrastructure internally.

 

Thanks for all the feedback, most probably this is due to printer going in sleep mode.

 

Get notified when there are additional replies to this discussion.