MS130 Switches - IP Address

[BLong]

We've ordered a handful of MS130 and MS130r's and each one seems to refuse to grab the correct IP range even though we have the vlan set correctly. It's constanly grabbing a native VLAN IP from DHCP.  After deleting the item in DHCP and factory resetting them a couple times they eventually grab the correct range. 

Has anyone else noticed this and if so what did you do to fix it? We never had this problem until the new series. 

Thanks

[pjc]

I found the same issue with a MS130, I had to configure the VLAN and DHCP option in the switch under LAN IP settings for the specific switch i.e. below

[BLong]

I have that configured already ☹️. I'm upgrading all the firmware  to see if that helps.