Legacy Catalyst voice configs to Meraki config

[bigkeoni64]

Hello

I have a network that's been up for almost 10 years and going from the old CAT 3560s and 4507s to MS225s. SHould I just leave the voice settings as-is on the Meraki's and they are smart enough with all the que'ng? Here is a typical configuration for a phone on an old CAT switch:

interface GigabitEthernet1/0/10
switchport access vlan 71
switchport mode access
switchport nonegotiate
switchport voice vlan 72
srr-queue bandwidth share 10 10 60 20
queue-set 2
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
spanning-tree portfast
spanning-tree guard root
service-policy input AutoQoS-Police-CiscoPhone

[ww · Accepted solution]

If you just want to trust your dscp value  then you dont have to do anything.

If you expect to have congestion  and want to use qos then you need to configure it. https://documentation.meraki.com/MS/Other_Topics/MS_Switch_Quality_of_Service_Defined

[bigkeoni64]

Excellent, I will trust.