Hello   I have a network that's been up for almost 10 years and going from the old CAT 3560s and 4507s to MS225s. SHould I just leave the voice settings as-is on the Meraki's and they are smart enough with all the que'ng? Here is a typical configuration for a phone on an old CAT switch:   interface GigabitEthernet1/0/10 switchport access vlan 71 switchport mode access switchport nonegotiate switchport voice vlan 72 srr-queue bandwidth share 10 10 60 20 queue-set 2 priority-queue out mls qos trust device cisco-phone mls qos trust cos auto qos voip cisco-phone spanning-tree portfast spanning-tree guard root service-policy input AutoQoS-Police-CiscoPhone ... View more

Hello   I currently have an 8 stack of MS225 switches with 2 different LAGs hitting the Firewalls. Since I can not mirror the AGG ports, I was thinking to mirror multiple source ports. Will there be switch CPU performance issues if I mirror all ports and I also mirror another switches ports to some other switch?   For instance can I mirror 48 ports on switch 2 of the stack to switch 1 port 48 of the stack, and at the same time mirror 47 ports to port 48 of itself? So that would equate to 95 ports being mirrored to Switch 1.   I am concerned about switch cpu performance.   Thank you ... View more

Can you set the aggregate ports on a Meraki stack to monitor ports and mirror them to another? I would like to monitor all traffic to and from the 8 stack of MS225 switches and this seems to be the best way to do it.  ... View more