Is there a show mac address table on MS's?

[CMTech1]

Hi,

I'm looking for a quick way to show the mac address table. I have the MS225's MS250' and I'd like to do what I use to on my old Cisco Switch hardware when using "sh mac-add" which shows the entire table with MAC, Port and VLAN. I can see the MAC in Meraki Switch under ports one by one, but can't figure out how to just obtain the entire list in one shot like I do with other Cisco Switches.

Thanks, Mark

[Andy84]

Hi CmTech,

Yes you can view the Mac Table by selecting the switch and going to the Layer 3 Routing Tab. The Mac Address table is underneath the list is limited to 100 entries however.

Thanks

[johnhinckley]

The MAC Address table is a function of Layer 2, so why would someone go to the L3 routing tab to see this?  Are you sure you don't mean the ARP table which is a function of layer 3?  

[CMTech1]

I was looking for both and already found what I needed, but that’s for asking. 

[CMTech1]

Thanks, I feel kinda stupid now as I keep forgetting about those tabs. Thanks for the quick reply and guidance though 🙂