Is there a show mac address table on MS's?

CMTech1
Here to help

Is there a show mac address table on MS's?

Hi,

 

I'm looking for a quick way to show the mac address table. I have the MS225's MS250' and I'd like to do what I use to on my old Cisco Switch hardware when using "sh mac-add" which shows the entire table with MAC, Port and VLAN. I can see the MAC in Meraki Switch under ports one by one, but can't figure out how to just obtain the entire list in one shot like I do with other Cisco Switches.

 

Thanks, Mark

4 REPLIES 4
Andy84
Conversationalist

Re: Is there a show mac address table on MS's?

Hi CmTech,

 

Yes you can view the Mac Table by selecting the switch and going to the Layer 3 Routing Tab. The Mac Address table is underneath the list is limited to 100 entries however.

 

Thanks

Thanks
Andy
CMNO
CMTech1
Here to help

Re: Is there a show mac address table on MS's?

Thanks, I feel kinda stupid now as I keep forgetting about those tabs. Thanks for the quick reply and guidance though 🙂
johnhinckley
Comes here often

Re: Is there a show mac address table on MS's?

The MAC Address table is a function of Layer 2, so why would someone go to the L3 routing tab to see this?  Are you sure you don't mean the ARP table which is a function of layer 3?  

CMTech1
Here to help

Re: Is there a show mac address table on MS's?

I was looking for both and already found what I needed, but that’s for asking. 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels