The guide says I can assign a port profile from the Swtich port menu.
But I can't find the menu.
Solved! Go to solution.
Is your network bound to a template?
Software requirements: While there are no minimum firmware requirements for Port profiles, MS 15.21.1 or later is recommended
Port profiles are currently not supported in Configuration Templates or networks bound to them. Support for Configuration Templates and networks bound to configuration templates will be added in the near future.
https://documentation.meraki.com/MS/Port_and_VLAN_Configuration/Switch_Port_Profiles
Is your network bound to a template?
Software requirements: While there are no minimum firmware requirements for Port profiles, MS 15.21.1 or later is recommended
Port profiles are currently not supported in Configuration Templates or networks bound to them. Support for Configuration Templates and networks bound to configuration templates will be added in the near future.
https://documentation.meraki.com/MS/Port_and_VLAN_Configuration/Switch_Port_Profiles
MS225
MS 16.7
Is the switch in a template?
Port profiles are currently not supported in Configuration Templates or networks bound to them. Support for Configuration Templates and networks bound to configuration templates will be added in the near future.
I am not using a configuration template.
I suggest you open a support case.
It was a C9300, not an MS225.
I was mistaken.
The MS225 is port-schedulable.
The 9300 cannot.
I can confirm after viewing two of my networks, one bound, and another not bound that this is the likely case here.