How to add access list in MS120-48

[Merakibgp]

Hi How to add access list in MS120-48. Anyone can send me a link on this? thank you

[jdsilva · Accepted solution]

Go here:

https://meraki.cisco.com/support/

And then type "MS ACL" in the search bar. The first result should be what you're looking for.

[Merakibgp]

Thank you!

[Merakibgp]

BTW, on the page, Switch ----> IPV4 ACL.

There i can see several ip addresses under "Dashboard IP address" What does that mean? 

[jdsilva]

@Merakibgp Those are the IP addresses of the Meraki Cloud. If you create rules you want to be sure you don't block access to those specific IP blocks as your devices will be unable to contact the cloud and you cannot manage them.

[PhilipDAth]

The MS120 is a layer 2 switch. I'm not sure it supports ACLs.

[jdsilva]

Oddly enough, @PhilipDAth, they do. 

[jdsilva]

https://meraki.cisco.com/products/switches/ms120-48#tech-specs

[BlakeRichardson]

You have two options.

Switch > Configure > ACL

OR 

Switch > Configure > Routing & DHCP

The MS120 series will only support the following  "This switch only supports interfaces for DHCP relay and IGMP snooping querier functionalities." 

You cannot setup L3 routing ACL on this model of switch. 

[Adam]

@BlakeRichardson

Isn't it Switch>IPv4 ACL or is that just a difference in our interfaces?

[jdsilva]

@Adam Maybe it's a version thing? I have both in my dashboard in different networks...