Deployment Meraki MX100 and MS250 switchs

HShanata
New here

Deployment Meraki MX100 and MS250 switchs

Hello, We just moved to Meraki devices for our network, 1 MX100 and 8 MS250

 

What is currently setup is  each 4 switches are connected as physical stack ( 2 x 4 MS250 ) stacking cables.

 

Each stack connected to the MX100 with 1 uplink. 

 

I setup the VLANs routing on one stack and everything working as it should.

 

when I connected the 2nd stack and give one of the ports a Vlan number it took the IP and its working fine.

 

What I found that all the 2nd stack switches have RSTP enabled and passing traffic ( I think ) from the uplink of the 1st stack as its the one that have routing enabled . 

 

everything seems to be working fine but want to know what is the best way for this configuration.

2 REPLIES 2
HShanata
New here

Screen Shot 2018-12-16 at 12.35.14 PM.pngThe main stack is Suite 300 and the not routed one is Suite 200
Screen Shot 2018-12-16 at 12.34.48 PM.png

PhilipDAth
Kind of a big deal
Kind of a big deal

Typically I would make one switch stack the "core" switch stack. I would then connect the MX and the second switch stack to that.  I would give the "core" switch stack a spanning tree priority of 0.

 

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels