Meraki switch MS120-8LP

[Peterja21]

I am new to Meraki.  I want to connect an MS120 to my existing network port so I can connect my voip phones and laptop to the Meraki and be on my company network.  When I connect my network cable to one of the ports on the Meraki, I’m not able to connect.  My network port is vlan 10, the Meraki ports I think are all vlan 1.  My network port is an access port.  How must I connect/configure  my Meraki switch ports and network port to get this working?

[ww]

a meraki switch is not different then other vendors.

most common is to connect both switches with a trunk and allow the vlans you want to access on both sides. all other ports you can set as access ports and define the data and voice vlan you desire

[PhilipDAth]

Do you have control over the switch you are plugging into? 

[BlakeRichardson]

The port on the swithc you are plugging into should really be set as a trunk port. 

[Peterja21]

thank you