ACL for IPV4 is not available

SOLVED
hkholghi
Comes here often

ACL for IPV4 is not available

I'm trying to add a simple ACL rule and I get an error message that the source and destination must be IPV6.  My network is an IPV4.  Here is a screenshot of the rule and error message. Screen Shot 2021-08-02 at 6.27.24 PM.pngAny idea how can I add an IPV4 rule?

Thank you.

1 ACCEPTED SOLUTION

i was going to suggest the same. almost all the switches were on ancient firmware from 2017 and that's likely the issue.

View solution in original post

2 REPLIES 2
hkholghi
Comes here often

No.  There are no trailing spaces before the subnet.  I just heard from Meraki support that I need to upgrade the switch firmware.  I hope this fixes the issue.

i was going to suggest the same. almost all the switches were on ancient firmware from 2017 and that's likely the issue.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels