Nov 27 2018
10:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
10:22 AM
MV72 cable install guide video & documentation
There is now a video that goes through how to assemble the MV72 cable connection. This is the companion to the written documentation available here. Following this guide will help ensure your camera is able to meet it's IP67 rating for the prevention of water ingress.
5 Replies 5
Nov 27 2018
10:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
10:58 AM
Haha now I want the MV72 Bathtub Cam to be a thing 🙂
Or maybe, for privacy reasons, it should be an Aquarium Cam...
Nov 27 2018
11:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
11:12 AM
When assembled correctly the camera is water tight. I ran one for a few days in a bucket of water.
Nov 27 2018
1:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
1:03 PM
Great video! Thanks George!
Nov 27 2018
2:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
2:27 PM
If putting a camera in a bucket of water isn't standing behind your product then I dont know what is!
If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.
Nov 27 2018
4:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 27 2018
4:17 PM
Good video!
Bonus points if you did it using an MV.
Get notified when there are additional replies to this discussion.