VPN firewall use case

ozgurguler
Meraki Employee
Meraki Employee

VPN firewall use case

Hi

We want to apply a firewall filtering for a vlan in branches. Each branch has 5 vlans and there are hundreds of branches. We are using a template to manage them all.

Because regular firewall doesn't check packets which go through VPN, we can't apply a firewall rule for a vlan. However VPN firewall which works organization-wide does only support IP/subnet which means i have to configure every vlan seperately which is not feasible. Is there any easier way to do this?

 

Thanks

3 Replies 3
PhilipDAth
Kind of a big deal
Kind of a big deal

No doubt about it, this is a painful situation.

 

If you are lucky you might be able to put in rules like any -> destination set of subnets, if the destination set is not too large.

 

If the branches weren't deployed yet sometimes it is better to allocate VLAN"x" subnets from a larger supernet, like 10.x.branch.0/24.

 

But on the whole, there is no nice Cisco Meraki solution for this situation.

stroighne2
Conversationalist

Hi,

 

I think I have a similar set-up. Our sites have 4 additional vlans, which I've named, so these can be and pre-configured as part of the template. However , like you I have to configure each individual MX as and when it's deployed. Which will become a pain, I'm sure. 

 

Cheers.

thomasthomsen
Head in the Cloud

My new Wish regarding this 🙂

"We wish for a button that could make the global firewall also work on the VPN traffic.
Creating rules in the global firewall, and not being able to see / use those on the VPN traffic is just not optimal.
This would be a major thing."

 

/Thomas

Get notified when there are additional replies to this discussion.