Non-Meraki Site-to-Site over WAN 2 MX100

[mdgoblue]

I'm new to Meraki so please have mercy, LOL.

I have 2 circuits (WAN1 and WAN2).  Primary Uplink is WAN1.  I wanted to know if it is possible to dictate which uplink to use for my non-Meraki tunnels.

For example, I have 15 site-to-sites.  I would like a couple of them to peer over WAN1 and a couple over WAN2...is that possible?    

[DarrenOC]

Hi @mdgoblue , Under the SD-WAN page you’re only options are

Active-Active VPN Enabled: Create VPN tunnels over all of the available uplinks (primary and secondary).

Disabled: Do not create VPN tunnels over the secondary uplink unless the primary uplink fails.

[PhilipDAth]

It uses the configured primary uplink under "SDWAN & Traffic shapping".  You can then create a flow preference to direct Internet traffic out over the other link.