cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Meraki Firewall Settings

Highlighted
Just browsing

Meraki Firewall Settings

Hi,

We have a Meraki MX100, and we have set a firewall settings on Layer 3 and enable specific ports and lastly deny others. I have a mobile app Hik connect and view IP camera in other offices. But after Firewall settings we are unable to view ip camera video. Can anyone tell me the port number which i should enable and view through mobile apps.

 

Regards

Palash

Palash
6 REPLIES 6
Highlighted
Kind of a big deal

Re: Meraki Firewall Settings

Do you have an exact model for the camera?

Highlighted
Just browsing

Re: Meraki Firewall Settings

Hik Vision NVR Model: DS-7616NI-E1

HIk Vision IP Camera Model: DS-2CD1230 and DS-2CD1331-I

 

 

Palash
Highlighted
Kind of a big deal

Re: Meraki Firewall Settings

You should ask the people you got the camera from what the firewall requirements are.

Highlighted
Kind of a big deal

Re: Meraki Firewall Settings

I'd have a look at the manual that came with the camera, differnet brands and different models even can use completely different ports. 

 

Most use RTSP or HTTP but some vendors use non standard ports for these. 

Meraki CMNO, Ruckus WISE, Sonicwall CSSA, Allied Telesis CASE & CAI
Highlighted
Just browsing

Re: Meraki Firewall Settings

I have already asked the people who delivered the camera and suggested the ports (8000,554,8200) are allow and we did it but we can't view my mobile through HIk Connect Software. But If I allow all in firewall settings then we can access.

Palash
Highlighted
Kind of a big deal

Re: Meraki Firewall Settings

Although the documentation is not very clear I find 80, 8000 and 554 here:

https://www.hikvision.com/ueditor/net/upload/2015-06-10/3b56a0c6-f61c-4381-866e-dc49e5c30c88.pdf

and here:

http://specsheets.dvs.co.uk/Hik%20connect%20-DVS.pdf

 

For local access from another subnet in your network it's those ports that you'll have to open up.

 

For remote access from the internet, there are two options:

  • Either you setup port forwarding for those ports. Note that forwarding port 80 means that the MX's local web page may not work anymore. You could use an alternative port as they do in the first pdf (they use 8008 instead).
  • Or you setup 1:1 NAT if you have a free WAN IP. Make sure you close off the firewall and only open up those three ports.

If there's a NAT router in front of the MX you'll need to configure forwarding in that too.

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.