Hello all,
we have connected to one branch 10 IPSec connections.
After changing something in the Non meraki VPN config, ALL IPSec connections are disconnected.
I cannot understand this behaivor.... do you have the same problems?
Best regards
Robin
What change?
On some changes it resets wan interfaces (according to the documentation)
"
Note: Modifying the following items will result in WAN interfaces being reset.
This will result in a loss of connectivity on both Internet uplinks for up to 2 minutes. Therefore, it is recommended to only make changes during a planned maintenance window so that disruption is minimal. "
"Making changes to Non-Meraki VPN settings under Security & SD-WAN > Configure > Site-to-site VPN, might result in existing Non-Meraki VPN tunnels bouncing. We recommend that you make changes during a maintenance window to minimize the impact of Non-Meraki VPN tunnels bouncing. "
https://documentation.meraki.com/MX/Site-to-site_VPN/Site-to-Site_VPN_Settings#Non-Meraki_VPN_Peers
Hello, Yes this is expected behavior. It is recommended to make changes to the Non Meraki peer settings during a change window
@AMP Expected behavior or is not implemented as it could be?
Could this be a nice feature that will make less trouble meraki customers? 🙂
In the bottom right-hand corner of the dashboard is a button called "Give your feedback". That is the best place to request new functionality.