How do I make the wifi network visible on my wireless network?

[Analogmatch]

I’ve setup my gx20 and I created a WiFi network. But the network is not visible on any of my devices. How do I make the wifi network visible on my wireless network? I turned off the radios on my at&t router but no luck.

[BlakeRichardson]

Have you enabled the network?

[Analogmatch]

Where do I enable the network? I don’t see this setting in the app. 

[Bruce]

@Analogmatch, are you using the mobile app or the website? You need to use the Website (dashboard.meraki.com) for most configuration, the app is great for monitoring though.

EDIT: Okay, just noticed this is a Meraki Go network - not sure if the same applies.

[Bruce]

I can't find anything that states that the GX20 has a WiFi interface in it - are you sure you have a GX20? Either that, or are you configuring a GR10 or GR60 access point? They are the Meraki Go wireless devices.

[Analogmatch]

My plan is to use the GX20 security gateway in conjunction with the ISPs router to monitor traffic and prevent  inappropriate usage. So I connected the GX20 to my modem and set it up in bridge mode as directed by the documentation. But maybe I don’t understand this system. So do I need the Meraki Wireless access point to create the WiFi network? Can I not continue to use the modems radio for the WiFi network?

[Bruce]

To create a Wifi network in the Meraki Go solution you will need a Meraki Go access point. You may be able to use the Wifi on the AT&T router (but that will need to be configured on the AT&T router) and pass the traffic from that through the Meraki Go device, but I don't know if that will work - it will depend on the capabilities of the AT&T router, and/or whether you can put the GX20 between the AT&T router and the internet.