May 2 2019
6:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 2 2019
6:31 AM
Fortigate site-to-site VPN to Meraki MX84
I would like to set-up a site-to-site vpn between a Fortigate FW (branch) to a MX84 (HQ). I know to add a peer to Non-Meraki peers section.
The problem i have is that the Fortigate is connected to a DSL and the ISP changes the assigned public ip address frequently.
Can this be configured any other way?
4 Replies 4
May 2 2019
6:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 2 2019
7:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 2 2019
7:14 AM
Are there any plans to allow 3rd party site-to-site vpn's when 3rd party FW's not on static public ip address? Customer can currently do this with their Fortigate. Why not allow FQDN name in the peer configuration.
May 2 2019
12:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 2 2019
12:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 2 2019
12:15 PM
@GuilhermeMacedo wrote:Even if you use a DynamicDNS or similar @jdsilva ?
Unfortunately, that doesn't matter. The Non-Meraki VPN config only takes an IP, not a name.
For example, if I enter this:
Then I get this error:
Get notified when there are additional replies to this discussion.