Meraki

AVC · ‎Apr 19 2023

Hi

We recently tried an AutoVPN to Umbrella, to tunnel all our internet traffic. Long story short, we had a few problems, and had to roll back.

Once the AutoVPN was removed, it left 2 unknown peers on our MX's.

Does anyone have any idea how to remove them (in case it matters, we use templates for our sites).

Thanks

alemabrahao · ‎Apr 19 2023

Have you tried this options?

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

AVC · ‎Apr 19 2023

Unfortunately, it isn't a non Meraki VPN Peer so it isn't listed there. It was auto created with Cloud on-ramp, but when you remove the deployment, it leaves behind these....which I cannot find a way to remove.

alemabrahao · ‎Apr 19 2023

Did you remove all Umbrella settings?

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

alemabrahao · ‎Apr 19 2023

Anyway, I suggest you open a support case.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

ww · ‎Apr 19 2023

Did you wait 24h? And then put the vpn status on: for the last day