Apr 19 2023
2:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
2:41 AM
AutoVPN to Umbrella
Hi
We recently tried an AutoVPN to Umbrella, to tunnel all our internet traffic. Long story short, we had a few problems, and had to roll back.
Once the AutoVPN was removed, it left 2 unknown peers on our MX's.
Does anyone have any idea how to remove them (in case it matters, we use templates for our sites).
Thanks
Labels:
- Labels:
-
Auto VPN
5 Replies 5
Apr 19 2023
3:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
3:46 AM
Have you tried this options?
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Apr 19 2023
3:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
3:51 AM
Unfortunately, it isn't a non Meraki VPN Peer so it isn't listed there. It was auto created with Cloud on-ramp, but when you remove the deployment, it leaves behind these....which I cannot find a way to remove.
Apr 19 2023
3:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
3:55 AM
Did you remove all Umbrella settings?
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Apr 19 2023
3:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
3:57 AM
Anyway, I suggest you open a support case.
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
Please, if this post was useful, leave your kudos and mark it as solved.
Apr 19 2023
6:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 19 2023
6:37 AM
Did you wait 24h? And then put the vpn status on: for the last day
Get notified when there are additional replies to this discussion.