AutoVPN over MPLS

SOLVED
JamesMutie
Getting noticed

AutoVPN over MPLS

Am struggling to find out which routing protocol I can use for L3 MPLS CE to PE peering on below MX Devices.

MX64W-HW, MX100-HW, MX84-HW, Z3.

 

What’s your recommendation for the above MX devices for routing protocol when doing AutoVPN over MPLS.

1 ACCEPTED SOLUTION
ww
Kind of a big deal
Kind of a big deal

Mx in one armed concentrator mode can run bgp

 

Mx in routed mode does not use dynamic routing protocol on wan. I just need 1 ip address (Or for warm spare 2 or 3(if you want vip)

 

All other ip/traffic is inside the vpn and not seen by the mpls. Or behind that wan ip that is used as nat address by the lan subnet.

 

In that case it would be static

View solution in original post

1 REPLY 1
ww
Kind of a big deal
Kind of a big deal

Mx in one armed concentrator mode can run bgp

 

Mx in routed mode does not use dynamic routing protocol on wan. I just need 1 ip address (Or for warm spare 2 or 3(if you want vip)

 

All other ip/traffic is inside the vpn and not seen by the mpls. Or behind that wan ip that is used as nat address by the lan subnet.

 

In that case it would be static

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels