Secure Connect:
Cisco Secure Connect Data Center List
Change: Marked a few sites where Site-to-site interconnect is not available yet.
MG:
Change: Added Spanish Hardware Installation Guides.
MX:
Change: Added section "Safety and Warnings", "Pre-install Preparation", "Configure your Dashboard Network", "Check and Set Firmware" and "Check and Configure Upstream Firewall Settings".
MX64 and MX65 Overview and Specifications
Change: Updated "Max VPN Throughput".
IPv6 Support on MX Security & SD-WAN Platforms - LAN
Change: Added note "RNDSS support requires a minimum firmware version of MX 18.205."
Change: Added "WAN appliances in Routed mode only support OSPF when using the "Single LAN" LAN setting. This can be set on Addressing & VLANs page."
Change: Added Spanish Hardware Installation Guides.
MR:
Change: Updated note "The AP is locked to approved antennas. Third-party antennas will not operate if inserted into the 2.4, 5 or 6 GHz ports."
Hotspot 2.0 Configuration Example
Change: Added note "If choosing to use a Hidden SSID, note that the SSID name and WPA2 passphrase are case sensitive. When configuring the wireless profile on the client device ensure that they are identical to how they are configured in Dashboard. If you do not have the SSID name value entered correctly on your wireless client, your device will not be able to receive a response from the AP when probing for the wireless network."
MV:
Meraki Vision Portal Changelog
Change: Added release notes for up to v1.17.6.
Third Generation MV Cameras: Overview and Specifications
Change: Added MV13 and MV33.
SM:
Windows BitLocker Encryption with Meraki Systems Manager
Change: Added note "Bit-Locker Keys are not stored in Dashboard and it is up to the administrators to securely store them. They cannot be stored on the managed endpoint's drive(s) that is being encrypted."
Systems Manager Agent Upgrade 2024
Change: Updated date to April 14, 2024.
General Administration:
Change: Added note "Analytics must be enabled under Network-wide > General's Location and scanning section in order for a network to include this in the Summary Report" to section "Number of sessions over time".
Configuring the Default Block Message
Change: Added note "This message will appear on the error page shown to blocked devices, unless those devices have client-specific block messages."; added instructions on how to set client specific block messages.
