Documentation Digest: December 18th - December 22nd

Meraki Employee
Meraki Employee

Documentation Digest: December 18th - December 22nd




Site-to-Site VPN Settings

Change: Updated phase 2 authentication types to MD5, SHA1 and SHA256 and phase 2 PFS groups to 1, 2, 5 or 14.


Client VPN Overview

Change: Added note that for RADIUS server authentication, the Server IP addresses are sorted in ascending order from lowest IP to highest IP. RADIUS traffic towards the servers are prioritized in the same manner, starting with the lowest IP address first. This behaviour cannot be modified.


Meraki MX ThousandEyes Configuration Guide

Change: Added supported regions; added warning that the Meraki Dashboard Account and ThousandEyes Accounts must belong to the same region.


vMX Comparison Datasheet

Change: Updated operating capabilities for all public cloud providers (start/stop machine, configure static IP etc.).



Switch Ports

Change: The option for Mac allow list and Sticky Mac allow list for MS390s is currently under limited release.



MR Overview and Specifications

Change: Added MR PDF datasheets.


CW9166 Installation Guide

Change: Updated note regarding Dual 5 GHz mode. The operating channels are restricted to UNII-1 and UNII-2 for the first 5 GHz radio and UNII-2e and UNII-3 for the second 5 GHz radio.



MV63 Installation Guide

MV93 Installation Guide

Change: Added note about Flashing Red LED state (insufficient PoE power).



Enrolling and Supervising iOS Devices using Apple Configurator 2.5 or Later

Change: Updated minimum macOS version to macOS 14 or greater.


General Administration:

Packet Capture Overview

Change: Added note that the capture will fail if packet capture is set to be taken on "All Access Points" and the number of access points in the network (both online and offline) is larger than 100.


Alerts and Notifications

Change: Added instructions on how to have email alerts forwarded as an SMS to a phone number.


Meraki Licensing FAQs

Change: Added FAQ "What permission level do I need to add or modify licenses?".


0 Replies 0
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.