New articles:
Change: New article.
MV84X Mounting Options and Guidelines
Change: New articles.
MX:
AnyConnect on the MX Appliance
Change: Updated reset / replacement behavior regarding certificates: "A factory reset or device replacement (RMA) will generate a new private key for that MX. As such, a new CSR will need to be generated, signed and the resulting certificates will need to be re-added under Security & SD-WAN > Configure > Client VPN > AnyConnect."
Change: Added "Firewall rules only apply to traffic passing through the firewall. They don't affect traffic originating from, or terminating at, the firewall itself. For example, LDAP binds and client VPN connections are not affected by firewall rules. Also, MX VLAN interfaces and MX WAN IP addresses are not considered when the firewall evaluates Allow or Deny rules."
MS:
Connect Hybrid Operating Mode Catalyst Switch to Dashboard
Change: Added "This rollout happens in phases, and availability may vary. If the hybrid operating mode option is not visible when adding switches, it will be available soon. We are working to bring this feature to all eligible organizations."; added "When adding stacked switches, only the active member of the stack should be selected to add to network."
Change: Added C9300-M: "The VLAN qualifier is not supported on the MS390 and the C9300-M."
Change: Updated 40 Gbps SFP modules.
Packet Captures and Port Mirroring on the MS Switch
Change: Added "Meraki managed and monitored Catalyst switches".
MR:
Cloud-native IOS XE Wireless Controllers Design Guide
Change: Added "After the WLC and APs are added to the network, you can review the access point assignation that was originally selected by navigating to Organization > Monitor > Change log. You can filter the change log using the WLC's cloud ID and the label 'claim devices'."
Using Tags to Manage MR Access Points
Change: Added "Adding or removing a tag from an AP that is broadcasting SSIDs configured to use 802.1X with my RADIUS causes the SSIDs to restart on that AP and clients will be disconnected. Non-802.1X SSIDs remain unaffected."
MV:
Change: Added MV23 and MV73.
Change: Added MV84X; added "MV84X only supports Smart Retention operation."
General Administration:
Configuring DHCP Services on the MX and MS
Change: Updated behavior for mandatory DHCP: "If you have mandatory DHCP enabled, fixed IP assignments may not function properly. If the WAN appliance is rebooted, those clients won't be able to pass traffic until a new full DORA transaction is detected."
Change: Added "Only dashboard connectivity-related alerts are reflected on this page, such as Device(s) VLAN Mismatch, Misconfigured DNS and Bad IP Assignment Configuration, offline devices etc. In comparison, the Organization > Alert's page, provides more granular view - Organization Alerts and Alert Hub."
Best Practices in Viewing MV Video
Vision Portal: Attribute Search
Change: Added references to free online training courses on the Meraki Learning Hub.
@Hannah-C wrote:
New articles:
Using Tags to Manage MR Access Points
Change: Added "Adding or removing a tag from an AP that is broadcasting SSIDs configured to use 802.1X with my RADIUS causes the SSIDs to restart on that AP and clients will be disconnected. Non-802.1X SSIDs remain unaffected."
A change that increases reliability and accessibility on wireless networks is always welcomed!
