Tunnel is showing up but traffic not moving.

Shubh3738
Building a reputation

Tunnel is showing up but traffic not moving.

Tunnel is showing up but traffic not moving through second ISP only.

 

through 1st ISP tunnel is connected properly.

6 Replies 6
Ryan_Miles
Meraki Employee
Meraki Employee

You should contact Meraki Support

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
kevinchow
Here to help

What about your routing or network load balancing settings?

kevinchow
Here to help

Sd-wan & traffic shaping > uplink configuration

WAN2 make sure is not 0

 

Sd-wan & traffic shaping > uplink selection

load balance enable

 

Are you taking about VPN tunnel or WAN?

Shubh3738
Building a reputation

VPN Tunnel

PhilipDAth
Kind of a big deal
Kind of a big deal

Have you created any performance classes that affect which AutoVPN tunnel is used?

https://documentation.meraki.com/MX/Firewall_and_Traffic_Shaping/MX_Load_Balancing_and_Flow_Preferen... 

PhilipDAth
Kind of a big deal
Kind of a big deal

Have you got AutoVPN configured to load balance and use both ISPs?

 

If you take down the primary circuit, is the second circuit used?  Perhaps you only have it configured or failover.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.