I am in the midst of configuring a new network, which is a clone of another network.
It is going to be in the same SDWAN topology, and same settings and structure, but simply with a different IP subnet.
Due to customer constraints and control of IP segments, it is not possible to use a Template, and assign IP subnetting from that.
In order to create this new Network, I'll have to remove _all_ configuration from the new Network (static routes, DHCP subnet reservations, etc. in order to simply change the IP segment on Addressing and VLANs page. Afterwards, I can then go ahead to reconfigure all other settings, rather than just having to change a single octet in a few IP adresses.
Could it be possible to create an "advanced" configuration setting, which would allow experienced users to acknowledge the impacts, and allow one to force Configuration changes?
Note: This has also been submitted to the "Make A Wish"-foundation...
LinkedIn :::
https://blog.rhbirkelund.dk/Like what you see? - Give a Kudo ## Did it answer your question? - Mark it as a Solution
🙂All code is provided as is. Responsibility for Code execution is solely your own.
