Dashboard Throughput

Solved
Tazio4436
Here to help

Dashboard Throughput

I have an internet line of 1 G coming from ISP. It goes in to Cisco SW on port 1. Then port 2 of that SW is connected to my Primary MX 100 and port 3 of the same SW to the Secondary MX100.

When I am doing a throughput test on both MX100 I am getting only 280 Mbps.

is this correct?

Thanks for your reply

 

Tazio

1 Accepted Solution
cmr
Kind of a big deal
Kind of a big deal

@Tazio4436 the dashboard throughput is only an indication of functionality.  The MXs generally can manage up to a couple of hundred Mbps, the MRs not too far behind but the MSs only 10-20 MBps, if you hover over the (i) it explains that it is just really a connection test:

 

cmr_0-1607536795575.png

 

View solution in original post

3 Replies 3
ww
Kind of a big deal
Kind of a big deal

Better connect a client to mx. And use  a (reliable) speedtest from there 

 

https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Throughput_test_to...

cmr
Kind of a big deal
Kind of a big deal

@Tazio4436 the dashboard throughput is only an indication of functionality.  The MXs generally can manage up to a couple of hundred Mbps, the MRs not too far behind but the MSs only 10-20 MBps, if you hover over the (i) it explains that it is just really a connection test:

 

cmr_0-1607536795575.png

 

Thanks a lot.

 

Regards

Tazio

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.