Missing Passthrough Mode MG41E

[UnkeptBedroom]

Hello,

I am currently trying to configure a MG41E for passthrough mode. It is in a network bound to a template. In either the template Cellular Gateway settings, or the gateway itself's settings, there isn't an option to set it to passthrough as shown in Meraki's documentation. Any suggestions? 

Thank you, 

[Ryan_Miles · Accepted solution]

Is it running firmware 3.0? Passthrough was added then. From 3.0 changelog.

New feature highlights

• IPv6 support for MG21/41/51
• IP Passthrough support for MG41/51

[UnkeptBedroom]

It is not. I will update it and give an update. Thank you. 

[javalins]

This should work without issue, just tested.

[UnkeptBedroom]

Yep, that worked, thank you both!