Missing Passthrough Mode MG41E

Solved
WilfredoM
Conversationalist

Missing Passthrough Mode MG41E

Hello,

 

I am currently trying to configure a MG41E for passthrough mode. It is in a network bound to a template. In either the template Cellular Gateway settings, or the gateway itself's settings, there isn't an option to set it to passthrough as shown in Meraki's documentation. Any suggestions? 

 

Thank you, 

1 Accepted Solution
Ryan_Miles
Meraki Employee
Meraki Employee

Is it running firmware 3.0? Passthrough was added then. From 3.0 changelog.

 

New feature highlights

  • IPv6 support for MG21/41/51
  • IP Passthrough support for MG41/51

View solution in original post

4 Replies 4
Ryan_Miles
Meraki Employee
Meraki Employee

Is it running firmware 3.0? Passthrough was added then. From 3.0 changelog.

 

New feature highlights

  • IPv6 support for MG21/41/51
  • IP Passthrough support for MG41/51
WilfredoM
Conversationalist

It is not. I will update it and give an update. Thank you. 

javalins
Meraki Employee
Meraki Employee

This should work without issue, just tested.

 

javalins_0-1692303407327.png

 

 

 

WilfredoM
Conversationalist

Yep, that worked, thank you both!

Get notified when there are additional replies to this discussion.