Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About BSD54
BSD54
Comes here often
Member since Oct 24, 2023
Dec 19 2023
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Dec 18 2023
1:57 PM
Here is a sketch of my network. We are just trying to get the new layer 3 up and running broadcasting its' own VLAN so we know everything is working. This is my first experience getting a layer 3 switch up and running. I was handed this network so didn't have any part of the original setup. Is having the new Meraki Layer 3 running with the Catalyst Layer 3 messing it up. On the Meraki if I ping google from the 172.18.28.4 interface it works great. If I ping google from the 10.124.100.1 interface I get nothing.
... View more
Dec 18 2023
12:13 PM
I am trying to get our new Layer 3 Meraki up and running. I am having an issue with the test VLAN I set up not able to ping the gateway. I am not sure what I am missing. I can ping google from the management VLAN but not VLAN100.
... View more
Nov 1 2023
3:34 PM
Where I am getting confused is can I just plug it into a trunk port in my network and get it up and running.
... View more
Nov 1 2023
3:18 PM
I just had it plugged into our network through a trunk port. I created a couple of vlans on it just to play around but when a port is on those vlans it can't get to the out side world. If I have a port set to a vlan that already exists in my network then it works fine.
... View more
Oct 31 2023
3:40 PM
I have an MS425 that I am trying to get up and running with VLAN. When I create two VLANS I can ping from one to the other but I can't ping the out side world. I am trying to get it ready to replace an old Catalyst 3550. What should the uplink port on the switch be set to? When I look at the uplink port on the 3550 it is set to an access port but doesn't state what VLAN it is on. Thanks, Adam
... View more
Labels:
- Labels:
-
Interfaces
-
Layer 3
Oct 24 2023
2:39 PM
I am trying to set up my VLANS in the Meraki dashboard. The issue is that I am trying to create a VLAN to the interface of 172.18.28.2 which is the same ip as the switch. Do I not need to create VLAN 1 in the Routing and DHCP section of the Meraki dashboard. Below is the example of VLAN 1 on the catalyst switch. ! interface Vlan1 ip address 172.18.28.2 255.255.254.0 !
... View more
© 2024 Cisco Systems, Inc.
