Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Martinni
Martinni
Conversationalist
Member since Oct 5, 2023
Oct 16 2023
Community Record
9
Posts
0
Kudos
0
Solutions
Badges
Oct 9 2023
1:04 PM
Gateway MR86: to Core to 3560 - no connectivity Repeater MR86: to Core to 3560 - no connectivity Both WAPs can reach core but none can reach 3560, after 3560 ping Gateway AP can ping but repeater no.
... View more
Hi, If there would be such ACL it would block the ICMP all the time right? And ICMP works in specific situation. From 3560 all the time. And no I am not aware of such ACL.
... View more
Oct 9 2023
11:11 AM
Hi everyone, after solving issue with wrong VLAN configuration I have another one which I need help. This is my topology for the bridge connection: Issue: 1. Trying to ping Interface VLAN 840 from Core to 3560, no response..... 2. Then trying to ping DG 840 from 3560 to core, ping success. 3. After this successful ping I can do the ping in step 1. for about 30 seconds 4. Lose the connectivity from core to 3560 VLAN interface again..... If I SSH to device when its ping-able It will just cut me after those ~30 seconds Any ideas what might be an issue? Before all steps I make sure: 1. I have IP+MAC in ARP table on Core 2. ALL MAC in mac tables(all match) 3. Repeater has ARP entry of the SVI 840 on 3560 Any guidance or help appreciated.
... View more
Labels:
- Labels:
-
Installation
-
Other
Oct 9 2023
9:21 AM
thank you Ryan Miles. I was able to get basic connectivity but other issue arises after solving connectivity. will create another topic to not mix everything. PREVIEW
... View more
Oct 6 2023
6:57 AM
Yes, only single VLAN 1 needs to be bridged. version in original post.
... View more
Oct 6 2023
5:31 AM
Hi, we are trying to do bridge between two location(L2 LAN extension via WAPs), where we use these devices: 2x MR86 - version MR 26.7 1x Cisco C9200L 1x WS-C3560CX-12PC-S I have used this documentation: Extending the LAN with a Wireless Mesh Link - Cisco Meraki I was able to create bridge, I was also able to see MAC addresses of clients coming from the bridge. But I had no success to have connection to far side. Only difference with documentation as we do not use Meraki switches is this: Where I have chosen the Bridge SSID name. Is the bridge function limited to Meraki only switches and WAPs or is there a possibility to work with multi vendor ?
... View more
Labels:
- Labels:
-
Installation
-
Other
© 2024 Cisco Systems, Inc.
