Thats all good and well but who as access to every single AP model ever made by every manufacturer, as long as your meeting the customer requirements an you use the access point to determine your cell edges & attenuation measurements you can then model the network and optimise the network with a post validation survey. No need to do a full AP on a stick survey unless your in a really challenging environment IMHO & i have surveyed lots of challenging environments in the past. ... View more

have you set the relevant country code on the AP, once this is set then AP should show 5 & 6GHz as working, also dont forget the 6GHz to a PSC channel. ... View more

Why not survey with it, it provides 6GHz capabilities and if you know how to survey correctly it's not about the AP, its about attentuation, airtime utilisation, capacity & SINR. the AP is just to to prove you can get signal into the desired areas for the technology.   ... View more

Site survey mode on the CW916x models from a catalyst perspective you just have to ensure you have the correct image on the AP must be above 17.3 and it is a easy conversion to enable the AP to work in site survey mode. see below lin. https://www.jiribrejcha.net/2023/04/new-site-survey-mode-on-cisco-catalyst-wi-fi-6e-access-points/ Not sure if it would be similar on a meraki flavoured version not tried. ... View more

Just as i thought but i couldn't find that info when looking at the data sheet for the access point, didn't think to check the antenna documentation though. don't want to be ordering incorrect antenna   Thanks ... View more