Meraki Community

shun · ‎Jun 26 2023

you mentioned that; "Meraki MR36 will be sending untagged packets to try and DHCP an IP address." Therefore, I changed the VLAN set of the downstream port of HPE ProCurve 2520 to "Untagged VLAN 1", but MR36 still could not connect. Next, I changed the VAN set on both the HPE ProCureve's upstream and downstream ports to "Untagged VLAN 1" and the MR36 connected successfully. I also tried it with the NETGEAR unmanaged plus switch GS108PE, but I was able to connect only by setting VLAN 1 to Untagged on the downstream port only. I think the default VLAN 1 is handled differently depending on the manufacturer. thank you very much.

shun · ‎Jun 25 2023

Hello There, I want to connect MR Wireless AP Via HPE Procurve Switch Meraki MS390 --> HPE 2520 --> MR36 Meraki MS390 Port setting: "Trunk" 　↓ HPE ProCurve 2520-8G PoE Upstream/Downstteam Both Port setting: VLAN "Tagged" (same VLAN as Meraki MS) 　↓ Meraki MR36 (same VLAN as Meraki MS) After setting, Meraki Dashbord can not discoverry / connect MR36 AP MS390 port connection displayed HPE Switch ONLY. Let me know how to connect MR via Procurve SW B/R

Meraki Community

About shun

shun

Community Record

Badges

Re: MS and MR connection via HPE Procurve SW

MS and MR connection via HPE Procurve SW