Meraki

StarBlink · ‎Nov 17 2023

Balanced yes. OK makes sense now...

StarBlink · ‎Nov 17 2023

Thats done it. Thanks

StarBlink · ‎Nov 17 2023

I have AMP and IDS enabled (MX85) however I have never seen a single log in the security centre for three years! Support desk have not given any solution they just say try disabling and re-enabling these features but it never works. Any ideas why I am not seeing any logs for this?

StarBlink · ‎Nov 15 2023

I currently have this situation, does MX 18.107.2 still have this Meraki VPN - Non Meraki VPN routing limitation?

StarBlink · ‎Jun 1 2023

Thanks, this one is very useful to know about but not right for this as the remote device needs to see a certain destination IP in order to route and then remote side will NAT again to the original dest IP in a different system all together. Like double NATing. So definitely need a destination NAT feature.

StarBlink · ‎Jun 1 2023

I need to do a destination NAT on the MX to avoid routing issues across VPN/Azure. Is this possible on the MX85? Currently only 1:1 NAT and 1:Many NAT is available and they are both source NAT from inside. What I'm trying to do: 1. Packet arrives from internal LAN at MX 2. Gets NAT'd Original: Source IP-A > Dest IP-Z NAT :Source IP-A > Dest IP-Y 3. Passes across VPN to Azure

Meraki

Community

About StarBlink

StarBlink

Community Record

Badges

Re: Security Centre has never shown any logs

Re: Security Centre has never shown any logs

Security Centre has never shown any logs

Re: Non-Meraki VPN peer + Meraki autoVPN - routing

Re: MX device Destination NAT

MX device Destination NAT

Re: Non-Meraki VPN peer + Meraki autoVPN - routing