Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Become a member of the Cisco Meraki Community today
Get answers from our community of experts in record time.
Join now- About rpidcock1
About rpidcock1
Community Record
9
Posts
1
Kudos
0
Solutions
Badges
Friday
I have an MX105 deployed at one of my branch locations that has a SMF (Single Mode Fiber) connection to my main office building. I'm attempting to build 10G connectivity across that SMF, but have been unsuccessful to establish link. Summary of my scenario below. Main site has a 4500x, remote site has MX105, single mode fiber between locations. I'm using an "SFP-10G-LR-S" optic on each side of the connection. I have confirmed the ability to establish link to a 3850 switch at the remote site using the same optic and fiber. My question is, does the MX105 have a hard requirement to have a "MA-SFP-10G-LR" to establish this connectivity? Will it be compatible to connect with the "SFP-10G-LR-S" on the opposite side of the connection, since the 4500x doesn't show support for the "MA-SFP-10G-LR" module? Thanks in advance.
... View more
Dec 3 2025
1:03 PM
I have an MX105 pair in HA mode and I'm peering eBGP with my collapsed dist/core 9500. I see that I'm learning routes on my 9500 from my MX105, however I'm not seeing any learned routes on the route table of my MX105. Should I see learned routes?
... View more
Dec 19 2024
11:13 AM
I'm actively working on trying to get a site setup with this very scenario. My problem is that I have different ASN's at my remote branches (i.e. 646xx where xx = branch number). I'd love to visit with you sometime if you had a few minutes to chat about the overall setup. Maybe we could compare notes a little as to our specific network environments. Send me a direct message if you'd like to try to link up for a brief discussion.
... View more
Dec 19 2024
10:38 AM
So in this scenario, did you peer any routing protocols with the MPLS provider? Did you enable BGP on your MX?
... View more
Dec 19 2023
12:21 PM
Thanks, I know this is some time after my original post. I met with my Cisco rep today and he's going to get an MG21 for me to trial. I think that will help my situation, at least I hope.
... View more
Oct 31 2023
8:22 AM
Is it possible to extend the antenna connection on an MX67C device. I have the device installed inside of a kiosk building and would like to have the antennas mounted externally for better signal reception. Is this an option? Is there an extension kit that can be purchased?
... View more
© 2026 Cisco Systems, Inc.
