Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About aedm87
aedm87
Conversationalist
Member since Jun 5, 2018
Jan 31 2022
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Sep 30 2019
7:37 PM
Hi community, In this opportunity I have a doubt about How the MX aplies the rules of traffic shaping? Really only apply this rules under traffic that goes through of an auto vpn? and not also to the traffic that going toward web sites on Internet? The document SD-WAN and Traffic Shaping indicate that is only to my first ask, but I would like confirm with you this behavior. Please I waiting your feedback!
... View more
Mar 18 2019
7:48 PM
Wow that if is bad. If the world is not perfect because technology has to be =(
... View more
Mar 18 2019
9:38 AM
Hi Nash, Are you trying to do something like AutoVPN as well as MPLS? Yes, that is the objective. The documentation that you mentionate I have review it already. But in my case is necessary two wan active to run SD-WAN and understand that is possible with one DIA and one MPLS.
... View more
Mar 18 2019
8:46 AM
Hi Jdsilva, The Model is a MX67C, this model only has one wan but I enabled one lan port to that work it like a secondary wan. you want tell me that is not necessary converted one lan port to wan port to connected the mpls circuit? In that case, I understand then I would not really have load balancing between wan 1 and wan 2.
... View more
Mar 18 2019
6:52 AM
Hi Nolan, thank you for your response. For now I have not configured nothing in SD-WAN and Traffic Shaping. only enable wan 2 how primary uplink. In addressing and vlans only I have created the subnets and vlans of the lan. without static route and of course the mx in mode routed.
... View more
Mar 18 2019
6:37 AM
Hi dears, Community I need your help. MX-HQ - MX in the HQ MX-B - MX in the branch I am trying run SD-WAN between HQ and branch, in wan 1 have connected a DIA and in wan 2 have connected the circuit mpls. The communication in wan 1 is successfully to MX-HQ throug Internet, but the communication in wan 2 throug mpls is failed. I have tested make a ping from MX-B to MX-HQ through the mpls circuit but there is not response. however, a ping from MX-B to the router in the branch that want replace with other ip address is successfully. The segment mpls is a /25. so that all devices in this segment can see each other. Any idea about this issue.
... View more
© 2024 Cisco Systems, Inc.
