Meraki

RGN · ‎Feb 13 2024

Summary on my results: From ISP into an unmanaged switch. From the unmanaged switch, one patch cable to WAN1, second patch cable to WAN2 on Meraki. Each WAN with a static IP provided by ISP. Designated a specific VLAN for WAN2 by way of traffic flow rules. Thank you all for the help and advice!

RGN · ‎Oct 31 2023

Thank you, will share feedback later on.

RGN · ‎Oct 31 2023

For sure, having a second ISP would be the key factor, but limited at the moment. Fiber from ISP, existing equipment from ISP doesn't provide an extra WAN/Internet port from their equipment. Focus is more on isolating web traffic versus having redundancy with two ISP's.

RGN · ‎Oct 31 2023

Thank you for the info. Using the link provided by @alemabrahao my layout looks like this: I only have path going in and out provided by ISP. Still doable???

RGN · ‎Oct 30 2023

I have an MX84. ISP has provided multiple static public IP addresses. I have WAN1 connected to the modem/gateway from ISP. All traffic bypasses modem/gateway, into MX85 through WAN1. Is it possible to configure WAN2 with a second static public IP and have specific clients flow through WAN2? The goal is the following: 3rd party compliance vendor wants to isolate specific web traffic. Thanks!

RGN · ‎Aug 27 2022

Hello, I have a Wide Area meshed network multiple locations configured by the Primary ISP and they are on the same subnet. At the Primary location I have an MX84. At one of our locations, it has its own Secondary ISP, a Z3, with one client on it for specific web related usage. I would like to establish a Site to Site VPN between Primary and Secondary. I would like to have specific clients on Primary ISP, have all of its web traffic flow through Secondary ISP. Doable? Any thoughts and suggestions, I would appreciate it!

Meraki

Community

About RGN

RGN

Community Record

Badges

Re: MX84 WAN2 setup

Re: MX84 WAN2 setup

Re: MX84 WAN2 setup

Re: MX84 WAN2 setup

MX84 WAN2 setup

Site to Site VPN - Designating clients to a specific Network